Omniswitch 6800-48L - Alcatel OmniSwitch 6800 Series Hardware User's Manual

OmniSwitch 6800 Series Chassis and Hardware Components

OmniSwitch 6800-48L

The OmniSwitch 6800-48L is a stackable edge/workgroup switch offering 48 10/100/Base-T ports, as well
as four combo SFP ports for high speed connections.
The front panel of the OS6800-48L chassis contains the following major components:
System status and slot indicator LEDs
•
(44) 10/100Base-T ports
•
(4) Combo 10/100/1000Base-T ports
•
(4) Combo SFP slots for 1000Base-X connections
•
Console port (RJ-45)
•
An Optional 10 Gigabit module is also supported (see
Note. The 44 (non combo ports) 10/100Base-T ports on the OmniSwitch 6800-48L can be upgraded to
10/100/1000Base-T ports. Please contact your Alcatel representative for more information.
Refer to the illustration below for more front panel information. For detailed LED descriptions, refer to
page 2-13. For information on the chassis rear panel, refer to
Status and Slot Indicator LEDs
For detailed information on OS6800-
48L status and slot indicator LEDs,
refer to page 2-13.
OmniSwitch 6800-48L
TM
Speed 1 3 5 7
OK PRI
PWR BPS
FAN TMP
XFP1 XFP2
Speed 2 4 6 8
10/100Mbps and 10/100/1000 Ports
The OS6800-48L provides 44 fixed 10/100BaseT non
combo ports (1–44) and 4 fixed 10/100/1000BaseT
combo ports (45–48). These ports are auto-sensing
and auto-MDIX and use RJ-45 connectors.
OmniSwitch 6800 Series Hardware Users Guide
Combo SFP Ports
The OS6800-48L provides four combo SFP slots for 1000Base-X high-
speed connections.
By default, when an SFP is installed in a combo port, it takes over the port
number of the corresponding RJ-45 Ethernet port. In other words, if an SFP
is installed in the slot labeled 45, Ethernet port 45 is no longer available and
cannot be used for 10/100/1000 traffic. This default setting is referred to as
"preferred fiber." Refer to "Configuring Ethernet Ports" in the Network
Configuration Guide for detailed information, including steps for configur-
ing combo port settings.
9 11 13 15 17 19 21 23
10 12 14 16 18 20 22 24
OmniSwitch 6800-48L Front Panel
July 2005
page 2-15).
page 2-15.
25 27 29 31 33 35 37 39
26 28 30 32 34 36 38 40
Console Port
The OS6800-48L front panel provides one
RJ-45 port for console connections. Con-
sole connections are used by network
administrators for switch management.
This female RJ-45 connector provides a
DTE console connection.
OmniSwitch 6800-48L
41 43 45 47 LINK/ACT
45 47
46
48
46
48
42 44 46 48 LINK/ACT
Console
46 48
page 2-11