Cmm Front Panel - Alcatel OMNISWITCH 7000 Getting Started Manual

CMM Front Panel

Module Status LEDs
OK1. Hardware Status. Displays solid green when powered on and
the CMM has passed hardware diagnostic tests. Displays solid
amber when powered on and the CMM has failed hardware diagnos-
tic tests.
OK2. Software Status. Blinks green when the CMM is operational.
Displays solid amber when a system software failure occurs. Blinks
amber when the software is in a transitional state (e.g., when soft-
ware is being downloaded to the switch).
Redundancy LEDs
PRI. Displays solid green when the CMM is the primary (active)
management module.
SEC. Displays solid green when the CMM is the secondary
(backup) management module. For detailed information on CMM
redundancy, refer to your Hardware Users Guide.
Temperature/Fan Status LEDs
TEMP. Displays solid green when the CMM is operating within the
allowed ambient temperature range. Displays solid amber if a temper-
ature error occurs (i.e., the CMM is operating outside the temperature
range). Refer to the Hardware Users Guide for more information.
FAN. Displays solid green when all fans in the fan tray are running at
normal speed. Displays solid amber if a fan error occurs (i.e., one or
more fans are not running at normal speed).
Ethernet Management Port LEDs
LINK. Link Integrity Status. Displays solid green when an Ethernet
cable connection exists at the CMM's Ethernet Management Port.
ACT. Flashes green as data is transmitted or received on the CMM's
Ethernet Management Port.
March 2005
OK1
OK2
Module
PRI
Status
LEDs
SEC
TEMP
FAN
CONSOLE
/MODEM
EMP
LINK
ACT
Console/Modem Port. The CMM's front panel pro-
vides one RS232 port for console or modem connec-
tions. By default, this female DB-9 connector provides
a DCE console connection. However, by changing the
onboard jumper setting, the port can be changed to a
DTE modem connection.
For detailed information on changing the jumper set-
ting, refer to your Hardware Users Guide.
Ethernet Management Port (EMP). The CMM's
front panel also provides one Ethernet 10/100BaseT
port (copper RJ-45). This port provides out-of-band
network management and can be used for Telnet ses-
sions, switch diagnostics, and for downloading soft-
ware to the switch.
This 10/100BaseT port supports both 10BaseT and
100BaseT with auto-negotiation through the RJ-45
connector.
Hardware Basics 51