Alcatel OmniSwitch 6800 Series Hardware User's Manual page 51

OmniSwitch 6800 Series Chassis and Hardware Components
2
Starting from the top of the stack, insert one end of the stacking cable into either stacking port A or
stacking port B. The stacking port (A or B) depends on your preferred cabling pattern. Refer to
"Managing OmniSwitch 6800 Series Stacks"
cable connector is completely inserted and fully seated in the chassis.
3
Insert the other end of the stacking cable into the stacking port of the switch immediately below. Once
again, the stacking port (A or B) depends on the preferred cabling pattern.
4
Repeat this procedure until all switches in the stack are connected (see illustrations a, b, and c below).
Reminder. The diagram below shows one supported stacking cable pattern. For additional supported
cabling patterns, refer to
a
OmniSwitch 6800 Series Hardware Users Guide
for detailed information on cabling patterns. Be sure that
Chapter 3, "Managing OmniSwitch 6800 Series Stacks."
b
Connecting the Switches in the Stack
July 2005
Setting Up a Stacked Configuration
Chapter 3,
c
page 2-23