Trouble Shooting; Service History Notes - Calomax Clipper 2 5L Installation, Operation And Servicing Instructions

BASIC TROUBLE SHOOTING
Symptoms Possible Cause
Broken tap top
Normal level sensor
holding signal
No boiling water
Thermal cut-out
available
tripped (no light)
Element failed
Excessive internal scale. (See
'De-Scale' page 12)
Faulty wiring to thermistors /
faulty thermistors
Thermal cut-out
Temperature controller needs
trips regularly
adjusting
Element failed to earth
Defective Printed Circuit Board
Dirt in solenoid valve.
Over ows Level sensors require de-
scaling or replacing
Printed circuit board faulty
Page 20
Remedy
Replace tap top (or component)
De-scale
Reset and check for faults
Replace element
De-scale the boiler
(Particularly thermistor)
Repair / replace as required
Lower operating temperature
Replace element
Replace Circuit Board
Clean solenoid lter / or replace
solenoid, "work the boiler" -see
Service Instructions (page 12).
De-scale / replace sensors
Replace P.C.B
SERVICE HISTORY AND NOTES
Page 21