Timer Operation; Setting The Desired Temperature - Bellfires View Bell Medium 3 CF Operating Manual

Setting the desired temperature

• Select the desired mode of operation
briefl y.
• Press the SET button until the temperature indication on the display begins to fl ash.
• Set the temperature with
• Wait or press the OFF button briefl y to go to
• If the temperature control in
decrease
Important: Place the hand-held transmitter in a place that is not
infl uenced by direct sunlight, draught, heat from
the appliance and other heat sources.
Bellfi res
OPERATING INSTRUCTIONS

Timer operation

(The appliance must be in the standby position and the
pilot light is burning.)
Appliance functions automatically according to the two
pre-set heating periods;
P1 and P2. These heating periods repeat automatically
every 24 hours.
Also see: Programming the timer: P1 and P2.
The appliance works thermostatically at the pre-set
starting times P1
is automatically regulated to the pre-set day temperature
.
The appliance works thermostatically at the pre-set
stopping times P1 and P2
is automatically regulated to the pre-set night temperature
.
In order to allow the appliance to regulate the temperature
at night, the night
least 5°C.
If the
switch to stand-by at night. The appliance will automatically
operate at the following day cycle
N.B.: The pre-set temperature is shown on the screen
every 30 seconds.
(large fl ame) or
should be off (lower battery consumption),
the night temperature until
19
and P2 and the room temperature
and the room temperature
temperature must be set to at
setting is lowered to
or by pressing the SET button
(small fl ame).
mode.
appears on the display.
, the appliance will
.
Instructions for use