Before Operating - Bellfires View Bell Medium 3 CF Operating Manual

BEFORE OPERATING smell around the appliance area for gas. Be sure to smell next
to the fl oor because some gas is heavier than air and will settle on the fl oor.
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas
supplier's instructions.
• If you cannot reach your gas supplier, call the fi re department.
DO NOT use the appliance if any part has been exposed to or has been under water.
Immediately call a qualifi ed service technician to inspect the appliance and replace any
part of the control system and any gas control which has been submerged in water.
Use only the remote control to operate the appliance. Never use other means. If the
remote control does not function, try changing the batteries in the remote control and/
or the batteries in the receiver (see page 26 of this manual). If, after changing the
batteries, the appliance still not works, do not try to repair it. Call a qualifi ed service
technician. Force or attempted repair may result in a fi re or explosion.
The appliance is fully protected by means of a thermo-electric pilot light shut off in the
event of a gas escape from the main burner.
In addition, the appliance is equipped with a patented safety system, whereby the door
will relieve in a controlled manner a potential developing overpressure. Thus, by means
of a spring system, the door will tilt a few inches forward. This may cause a loud noise.
If this happens, immediately close the gas tap and call a qualifi ed service technician.
IMPORTANT:
keep a minimum distance of 40" from the front of the appliance. If the
pilot flame goes out for any reason, wait for 5 minutes before attempting
to re-ignite it.
Bellfi res
OPERATING INSTRUCTIONS
When igniting the pilot light and burner, always
10 Instructions for use