Set The Current Time; Set The Display - °C/24 Hour Or °F/12 Hour Clock Setting - Bellfires View Bell Medium 3 CF Operating Manual

Important: Setting up signal code before using the appliance for the fi rst time.
Before the appliance can be used, the receiver must fi rst learn the hand-held
transmitter's signal code.
• Press the "RESET"
are heard. See fi gure 3.
Release the "RESET"
• Press, within 20 seconds, the
until 2 short signals are heard.
If, however, a single long sound is heard, this means that setting the signal code has
failed or that the wiring has been connected incorrectly.
You only need to set up the signal code once. It is not necessary when changing the
batteries of the hand-held transmitter or receiver.
Bellfi res
OPERATING INSTRUCTIONS
Set the display - °C/24 hour or °F/12 hour Clock setting
• Connect the batteries. By simultaneously pressing OFF and
(small fl ame), can be switched from °F (and 12 hour clock)
to °C (and 24 hour clock), or vice versa.
• The display will automatically return to
time, but you may immediately return to
pressing the OFF button.

Set the current time

• The time display will fl ash after either:
a installing the battery or
b simultaneously pressing the
(small fl ame).
• While the screen is fl ashing, you can adjust the time.
• Press (large fl ame) to set the hour and
to set the minute.
• Wait or press OFF to return to
button on the receiver, and keep this pressed until 2 audio signals
button after the second (somewhat longer) audio signal.
(small fl ame) button on the hand-held transmitter,
The signal code has now been set up on the
15
mode after some
mode by
(large fl ame) and
(small fl ame)
mode.
receiver.
Instructions for use