Programming The Timer: P1 And P2; Operation (Remote Control); Igniting The Fire; Aux -Symbol On The Display - Bellfires View Bell Medium 3 CF Operating Manual

Programming the timer: P1 and P2

• Select the desired mode of operation
• Press the SET button until P1
in the display. (The time indication fl ashes.)
• Set the time for the beginning of the fi rst heating period by pressing
for houre and (small fl ame) for minute'setting.
• Press the SET button briefl y; P1 (OFF) appears on the display. Set the time for the
end of the fi rst heating period.
• Press SET again to set the second heating period P2
OFF).
• Wait a moment or press OFF to switch back to

AUX -symbol on the display

The AUX-symbol
burner" and "rear burner" are both being operated. All functions apply to both burners
together.
If the AUX-symbol
"rear burner" is turned off and all functions only apply to the "front burner"

OPERATION (REMOTE CONTROL)

Igniting the fi re
Bellfi res
OPERATING INSTRUCTIONS
(ON) (start heating period P1) and the time appear
on the hand-held transmitter's display indicates that the "front
on the hand-held transmitter's display is not visible, then the
• Open the gas supply valve in the gas pipe to the fi re.
• Switch the hand-held transmitter to the
• On the hand-held transmitter, press the OFF and
(large fl ame) buttons simultaneously. A short tone
will signal the start.
Release the buttons. Short beeps will then follow until
the pilot light and main burner are ignited.
Once the main burner has been ignited, the fl ame
height will automatically rise to the maximum position.
20
by pressing the SET button briefl y.
(heat ON) and P2
mode.
(large fl ame)
(heat
position.
Instructions for use