Table of Contents
Advertisement
2
FOLLOW THE INSTRUCTIONS BELOW REFERRING TO THE KEY TO CONTROLS AT THE END OF
THIS MANUAL.
2.1
FILLING THE WATER TANK
1. Remove the drip tray (1).
2. Then remove the container (4) and fill it with cold drinking water.
3. Fit in the water tank (4), pushing it in as far as it will go, and place the drip tray (1).
WARNING !!
When installing the appliance for the first time, it is necessary to proceed as follows:
1. Plug the appliance into the mains power; the power control light (22) will flash to show that the appliance
is connected to the mains electricity (Stand-by).
2. Press and hold down the buttons ON/OFF (27) and hot water delivery (23) together until water begins
to come out of the delivery group (10).
3. During this stage, the control lights to signal no water (13) and the power control light (22) will flash
and the pump will operate.
4. Release the buttons ON/OFF (27) and hot water delivery (23) to stop the boiler filling cycle. The
appliance will automatically return to Stand-by mode.
2.2
SWITCHING ON AND HEATING THE APPLIANCE
1. Press and hold down the button ON / OFF (27) for about 3 seconds; the green control light (22) will
go from flashing to lit to show that the appliance has been switched on; at the same time, the control
lights from 14 will 21 switch on for about one second (electronic system check).
2. The control light for the set temperature value will start to flash to indicate that the coffee delivery group
is heating up and the automatic boiler refill will be activated until the water level set by the manufacturer
has been reached.
3. Once the filling stage is complete, the boiler control light (13) will begin to flash, indicating that the
boiler is heating up. The first time that the machine is switched on, this will not be enabled until the
group reaches the set temperature.
4. Attach the filter holder (11) to the delivery group (10).
5. Wait until the appliance reaches the set temperature, making sure that the control lights on the control
panel (9) switch on progressively as the temperature increases. This starts as soon as the temperature
reaches the minimum setting (85°C for the MINI VIVALDI, or 91°C for the MINI VIVADI II), with the
switching on of the control light 14, and it will proceed until the appliance operating temperature has
been reached (the control light goes from flashing to lit).
6. When the group reaches the set temperature, the boiler heating function is enabled. Once it reaches
the set temperature, the control light will stay lit.
7. Every time that the temperature of the group or boiler drops below the set temperature, the control light
for the operating temperature will start to flash (appliance heating phase), until the set temperature is
reached.
8. The appliance is now ready for use.
WARNING!!
The boiler is activated by pressing the button "BOILER" (26). To deactivate the boiler, press and
hold down the same button for 3 seconds. When the boiler is switched off, it is not possible to
dispense hot water for infusions or to dispense steam.
NOTE.
The boiler status is stored to memory.
8
LSC 014 -UK- REV. 01
STARTING UP THE APPLIANCE
INSTRUCTION MANUAL
Hide quick links:
Advertisement
Table of Contents
