Advertisement
mounting the sliding Crosscut table to your saw:
15.
Remove the T-bolt (229) from the Crosscut Fence Lock Knob and insert the threaded shaft of the T-bolt up
through the slot on the fence as shown in Fig. 12. Pivot the fence clockwise and slide the T-bolt into the T-slot in
the left side of the sliding table top. Place the plastic washer (228) on the T-bolt threaded shaft and then screw
on the crosscut fence lock knob. Do not tighten the lock knob at this time.
Fig. 12
16.
Use a 5mm allen wrench to slightly loosen the miter gauge from the crosscut fence as shown in
Do not loosen the miter gauge screws more than 1 ½ full turn. If necessary, slide the fence left or right
to align the arrow on the miter gauge with the indicator on the fence for your saw type (ICS/PCS/CNS).
Retighten the screws, but not the lock knob. Now skip to step 20.
Fig. 13
SLIDING CROSSCUT TABLE INSTALLATION
Fig. 13.
15
Advertisement
