Advertisement
mounting the sliding Crosscut table to your saw:
3.
With the help of at least one other person to support the weight, turn the sliding table assembly over and
position it against the side of the saw table.
4.
Adjust the height of the sliding table to approximately match the saw table by turning the foot pads on the
bottom of the leg assemblies.
5.
Visually align the mounting holes in the side of the sliding table assembly with the holes in the side of the saw
table and then mark the set of holes to be used. See Fig. 6 for
Fig. 6
Fig. 7
6.
Pull out the sliding table lock knob on the underside of the sliding table assembly and rotate it 90 degrees to
unlock the sliding table. Then slide the table top toward the front of the saw to expose two of the mounting
holes, as shown in Fig. 8.
Fig. 8
ICS Model
Shown
12
SLIDING CROSSCUT TABLE INSTALLATION
PCS and CNS saws have 4 mounting holes.
Flush
ICS saws have 3 mounting holes.
Flush
saws, or Fig. 7 for
saws.
Standard
Standard
Advertisement
