Advertisement
modifying your table saw: unassembled saw
If your table saw is not assembled, follow these instructions in place of the instructions on Page 8 for modifying your saw rails
before assembling your table saw and attaching your Sliding Crosscut Table.
1.
Set out the front rail, rear rail, and main tube. (
2.
Mark the front rail, rear rail, and main tube, measuring from the left end. Refer to the table below for the
correct measurements.
To orient the tube properly, ensure the ruler is right side up when you are facing the
tube. Then, measure and cut from the left end.
3.
Use a metal cutting band saw to cut the front rail, rear rail, and main tube at the marks made in the previous
step.
Using other types of saws (such as a circular saw) can generate enough heat to blister
the powder coating. It is stongly suggested that you use a metal cutting band saw only.
4.
Remove any burrs or sharp edges with a file. Remove the plastic end cap from the cut off portion of the main
tube and install it on the new left end of the main tube.
5.
Install the front rail, rear rail, and main tube as you normally would when assembling your table saw, using the
instructions provided with your saw.
6.
For
saws only, follow steps 11-13 on page 8. For
needed.
Fence System
30" ( TSA-SFA )
30" ( TSA-PFA )
36" ( TGP-36 )
52" ( TGP-52 )
36" ( TGP2-36 )
52" ( TGP2-52 )
30" ( TSA-PFA )
36" ( TGP2-36 )
52" ( TGP2-52 )
36" ( TGI-36,
CBF-36 )
52" ( TGI-52,
CBF-52 )
10
SLIDING CROSSCUT TABLE INSTALLATION
Without Left Wing Installed
Front Rail
Main Tube
13 1/4
13 5/8
13 5/8
13 5/8
13 5/8
13 5/8
13 5/8
13 5/8
13 5/8
13 5/8
13 5/8
12 5/8
12 5/8
12 5/8
12 5/8
12 5/8
12 5/8
10 3/4
10 3/4
10 3/4
10 3/4
w/ 30" TSA-SFA does not have a front rail)
and
saws, no further modifications are
Cutting Point from Left End
With Left Wing Installed
Rear Rail
Front Rail
10 1/2
12 3/8
1 5/8
12 3/8
1 5/8
13 5/8
1 5/8
12 3/8
1 5/8
12 3/8
1 5/8
11 3/8
5/8
11 3/8
5/8
11 3/8
5/8
10 3/8
3/4
10 3/8
3/4
Main Tube
Rear Rail
1 1/4
1 5/8
3/8
1 5/8
3/8
1 5/8
5/8
1 5/8
3/8
1 5/8
3/8
5/8
5/8
5/8
3/4
3/8
3/4
3/8
Advertisement
