Advertisement
mounting the sliding crosscut table to your saw:
Before continuing, make sure the sliding table top is locked to the sliding table assembly. If the sliding table top
is not locked, pull out the sliding table lock knob on the bottom of the table assembly and rotate it 90 degrees,
then release. Slowly slide the table top toward the Home Position. The Home Position is where the front of the
sliding table top is generally flush with the table bottom. The lock knob should engage the table top and lock it
against further movement. This will help prevent injury due to the sliding table top moving unexpectedly.
1.
Turn the sliding table assembly upside down, slide the support leg T-bolts (109) into the sliding table T-slot
(see Fig. 4), then hand-tighten the legs clockwise to secure them in place.
Fig. 4
For the best
support, position
the legs near
the edges of the
sliding table, as
shown in Fig. 4.
2.
For
saws ONLY: Attach the switch box mounting bracket (113) to the underside of the sliding table
assembly using three M6x1.0x16 cap screws, three M6 washers and three M6 lock washers from the Auxiliary
Hardware Pack, as shown in Fig. 5. If you are mounting the Sliding Crossuct Table in the standard configuration,
align the holes in the bracket to the rear holes on the underside of the table (Fig.5-A). If you are mounting
the Sliding Crossuct Table in the Flush Configuration, align the holes in the bracket to the front holes on the
underside of the table (Fig.5-B).
Fig. 5
A
Standard Mounting Configuration
B
Flush Mounting Configuration
SLIDING CROSSCUT TABLE INSTALLATION
See the exploded
views on pages
20-21 for part
number labels.
11
Advertisement
