Set Mode; I Set Mode Programming - Icom IC-M502 Instruction Manual

Vhf marine transceiver

Hide thumbs Also See for IC-M502:

Table of Contents

SET MODE

Set mode is used to change the conditions of the trans-

ceiver's functions: scan mode (normal or priority), scan re-

sume timer, weather alert, dualwatch/tri-watch selection, DSC

watch, transceiver's beep tone, internal speaker (transceiver

or HM-127), LCD contrast (transceiver or HM-127), RF atten-

uation level, scrambler code and scrambler type.

• Available functions may differ depending on dealer set-

ting.

• The optional HM-127 has it's own settings for the beep

tone and LCD contrast.

• SET MODE CONSTRUCTION

q Turn power OFF.

w While pushing [16•9], turn power ON to enter set mode.

e After the display appears, release [16•9].

r Push [16•9] to select the desired item, if necessary.

t Rotate the channel selector to select the desired condition

of the item. Use [Y]/[Z] when using an optional HM-127.

y Turn power OFF, then ON again to exit set mode.

Table of Contents