Advertisement
www.aeroplusrc.com
g. Using the supplied bolts attach the pushrod at both ends. Check to see you have
sufficient movement of the aileron. If not adjust.
h. Repeat on other wing
Note: On wings using two servos be sure the servos are not binding. If the are you make have to
adjust linkages or use a product such as a match box
Gas Engine installation
1. Using the template that came with your chosen engine, using the cross axis on the engine box to
mark the mounting holes.
2. Check the diameter of the required bolts and drill accordingly.
3. Mount the engine with the stand offs to the bulkhead. Remember to use large washers on the
inside to spread the load and use plenty of thread‐lock.
Note: Depending on what engine is used you will need different length standoffs to get correct space in the
cowl
Note: To determine the standoff length needed measure the distance from the bulk head to the cowl ring
plus a little clearance. Then subtract the distance from the front up the engine hub to the back plate of the
engine. The difference will be the standoff length needed.
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
