Advertisement
www.aeroplusrc.com
2. Installing the elevator servos.
a. First test fit the servo into the servo mount. Some trimming make be required.
Note. Servo fits so spline is towards the front of the plane.
b. Now pre drill the servo mounts with a 1/16 drill bit, the secure the servo into the servo mount
with servo hardware.
c. Next remove the servo and use thin C.A. glue to reinforce the threads. After the glue is dry
reinsert the servo.
Note. Depending on servo arms used it may be necessary to install arm before reinstalling the servo.
d. Next install the servo linkages.
3. Extensions
a. Thread a 36" servo extension though the tube in the plane to the openings near the elevator.
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
