Advertisement
www.aeroplusrc.com
b. Connect the servo to the extension but be sure to use a servo clip or a piece of heat shrink to
4. Installing Elevator Halfs
a. Install the small carbon tube into the fuselage.
b. Slide the Elevator Half onto the tube.
Note: make sure the servo wire goes cleanly inside the fuselage and is not pinched.
c. Attached the elevator half to the fuselage with the provided hardware.
M3×12 inner hexagon screw & M3 wrench
5. Repeat the process for the other elevator half.
Rudder
1. Remove the covering where the rudder horns push through with either a hobby knife or soldering
iron.
2. Test fit the rudder horns
Note: Be sure the rudder horns are equal on both sides and in line with the hinge
point this is very important!
ensure it does not become disconnected during flight.
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
