www.aeroplusrc.com
3. Sand the area on the horn that fits inside the rudder so the glue bonds better.
4. Attaching the rudder.
a.
Insert the easy removal pin into the pin hinges.
5. Glue the rudder horns in the rudder with epoxy; wipe off excess glue while it is wet.
Note: Use the ball joint and bolt while gluing to maintain alignment.
Note: While still movable measure that the same amount pushes out each side. Care needs to be taken here
otherwise your rudder geometry will be incorrect.
6. Installing the Ruder Servo
a. If using the included ruder arm assemble the rudder servo control arm as below, drill holes for
screws and use C.A. glue to stop the nuts from coming loose.
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com