Table of Contents
Advertisement
www.aeroplusrc.com
Gas Engine installation
1. Using the template that came with your chosen engine, check the diameter of the required bolts
and drill accordingly.
2. mount the engine with the stand offs to the bulkhead. Remember to use large washers on the
inside to spread the load and use plenty of thread-lock.
Note: Depending on what engine is used you will need different length standoffs to get correct space in the
cowl
Note: To determine the standoff length needed measure the distance from the bulk head to the cowl ring
plus a little clearance. Then subtract the distance from the front up the engine hub to the back plate of the
engine. The difference will be the standoff length needed.
3. Exhaust options. The plane is equipped with a pipe tunnel so it will accommodate many kinds of
exhaust including stock, cans, and pipes.
AeroPlus RC Copyright 2014 © All Rights Reserved
service@aeroplusrc.com
Advertisement
Table of Contents
