Advertisement
www.aeroplusrc.com
b. Fit the rudder servo and drill holes using a 1/16 drill bit for the servo screws, then drop thin C.A.
glue into the holes to strengthen the wood.
Note: besure the glue has fully cured before installing the servo again.
c. Using servo screws fix the servo in place, note the spline is towards the front of the plane.
7. Installing the ruder cables
a. Thread the cables though the fuselage from the ruder to the servo trey
b. Loop the cable though the crimp and attachment point as shown below.
c. Crimp the cable using a pair of plies then trim cable.
d. Repeat this at the ruder end.
Note: be sure the cables are taunt but not over tight.
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
