Advertisement
www.aeroplusrc.com
Landing Gear Assembly
To prevent damage to the fuselage while the airplane is assembled we recommend fitting the landing gear first.
Note: Before starting ensure all of your parts are include.
Parts
CF Landing Gear
2 x wheel pants
2 x wheels
2 x axles
4 x collets
4 x M5 bolts
1. First Push each axle through the large holes and tighten up using 2 wrenches 13mm
2. Next Place a collet on the axle followed by the wheel, then another collet on the outside as per the
below diagram.
Note: Do not tighten up the collets yet as the wheel needs to be fitted so there is an equal distance within
the wheel pant.
3. The Landing gear rakes forward so use the correct wheel pant per side. Put a small amount of
thread‐lock onto the 2 x factory fitted blind nuts on the wheel pant.
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
