Advertisement
www.aeroplusrc.com
4. Fit the wheel pants over the wheel assemble and secure with 2 x cap head bolts.
Now line up the wheel in the center of the wheel pant opening and tighten the collets. Remember
5.
to use thread‐lock on the set screws and to make sure the wheel can move freely.
Rear Stab
1. Now glue the control horns into the elevators.
a. First use a sharp hobby knife to remove the covering from the slots.
b. Before gluing the area on the horns that goes inside the elevator needs to be roughed up with
sandpaper. This allows a better glue joint.
c. Using Epoxy now glue the two control horns into their respective places.
Note: it is highly recommended to install a ball joint in between the control horns to maintain
proper spacing during gluing.
Note: also please take care to make sure the linkage whole in the control arm is on the hinge line.
AeroPlus RC Copyright 2013 © All Rights Reserved
service@aeroplusrc.com
Advertisement
