Indicators And Messages - Kyocera FS-7000 User Manual

Indicators and Messages

Indicators and Messages

Indicators
5-8
This section explains the indicators on the control panel and the messages which appear in the
message display and the appropriate corrective action to take in each case.
Indicator
Fast Flashing
Slow Flashing
ATTENTION
Condition
The printer has run low on toner. The toner should be replaced
Flashing as soon as possible. Clean the printer after replacement. (See
Chapter 4.)
Toner is low or has run out. Replace with a new toner
Lit
container. (See Chapter 4.)
Paper is jammed in the location flashing.
The paper has run out in the paper cassette or multi-purpose
tray. Add paper to the paper feed source. (See Chapter 1.)
This indicates either the current paper feeder or the paper
Lit
output point.
A paper jam has occurred in the optional duplex printing unit
(DU-30). Remove the paper jam referring to the instruction
Flashing
manual for the DU-30.
An optional duplex printing unit (DU-30) has been attached,
Lit
and the printer is printing in duplex printing mode.
The printer is warming up (Please wait) or the printer
Flashing
has insufficient memory available. Confirm the message
indicated on the message display.
A message will be displayed in the message display. Take
corrective action according to the message displayed. The
Lit
table on the following page lists the corrective action to take in
response to each message.
Corrective Action