Pilot+ Controller - Permobil Street Service Manual

Pilot+ controller

Removal
1. Raise the seat to its highest position. To raise
it manually, see page 28, 31.
2. Put the circuit breaker in the "OFF" position;
see page 35.
3. Remove the rear chassis cover; see page 7.
4. Disconnect the electrical connections to the
pilot+ controller, being attentive to their
placement: see figure 64.
NOTE
The Pilot+ controller connectors A and E have the same function.
Cabling from SLS circuit board and control panel can therefore
be switched if desired.
5. Remove the Pilot+ controller by removing its
two attachment screws; see figure 65.
Fitting
Fitting is the reverse procedure.
A
B
C
D
E
Fig. 64. Pilot+ controller cable connections.
Fig. 65. The Pilot+ controller is attached
with two screws.
Fig. 66. Pilot+ controller
33
Pilot+ controller
A: SLS circuit board
B: Left drive motor
C: Power feed
D: Right drive motor
E: Control panel