Connect The Antenna Cable; Connect The Power Cord - BenQ VB3233 Quick Start Manual

V32B_V37B_EN.book Page 5 Wednesday, January 23, 2008 10:55 AM
4. After the shaft is completely
inserted, turn the TV so it faces
forward.

5. Connect the antenna cable

Connect a TV antenna cable fly-lead from your TV antenna system or Cable
TV (CATV) decoder box to the TV RF input socket on the TV (as shown in
the illustration below). Make sure that the cable connection is firmly in place.
• A poor quality TV signal will produce a poor picture and/or sound on your TV.
For high quality picture and sound, you will need a high quality TV signal.
Depending upon your location, for best TV signal reception, you should have a
properly aligned outdoor TV antenna system. If need be, consult a professional
antenna specialist.
• This TV has a built-in analog TV tuner, which requires the TV antenna cable
connection to an external TV antenna system or CATV decoder. If you wish to
make use of the digital LCD screen to view digital TV, you should connect an
external digital TV tuner (decoder) set top box (STB) to the TV using a digital
signal cable (HDMI or DVI) connection.

6. Connect the power cord

1. Locate the power cord from the packaging, and plug the appropriate end
into the
2. Plug the other end into an appropriate wall power outlet, and turn on the
switch (if the power outlet is switched). The TV will enter standby mode
and the power indicator (on the front lower right) will light up red.
AC-INLET
Power
outlet
Power cord
Antenna cable
TV RF input socket
AC-INLET socket on the rear of the TV (as illustrated below).
socket
Section 1: Quick Start Guide 5