Table of Contents
Advertisement
V32B_V37B_EN.book Page 9 Wednesday, January 23, 2008 10:55 AM
10. View the TV programs
Care and cleaning information
• Always turn off the TV and disconnect it from the mains power before
cleaning.
• Do NOT use cream, liquid, aerosol or spray cleaners. Use only a slightly
damp well wrung-out (drip-free) and lint-free, clean soft cloth and lightly
wipe the TV.
• If necessary, use a pH-neutral liquid dish-washing detergent diluted with
water on a separate clean lint-free cloth to remove oil or grease marks. Wipe
over again with a clean dry lint-free cloth to remove any smear marks.
• Under close examination and in certain circumstances, you may notice that a
few non-active pixels appear on the screen as a fixed point of color. Please
note that this does not affect the performance of your product as it is usually
not visible at normal viewing distances.
• If the TV is not going to be used for an extended period of time (like when
you are going away for holidays), it should be switched off and unplugged
from the wall outlet. You should also consider removing the batteries from
the remote control (as they may leak).
• LCD (Liquid Crystal Display) screens, like plasma (PDP) and conventional
CRT (Cathode Ray Tube) screens, are also susceptible to 'screen burn-in' or
'image retention' which can be found on the screen as visible fixed lines and
To sequentially change the TV programs available in your area,
press the following buttons:
P (Program)
P (Program)
•
or
(as highlighted in the illustration), or
•
or
on the remote control, or
•
or
on the TV.
You can also change to a program directly by selecting the
station number using the numeric program selection
button(s) on the remote control:
• To select a single-digit program number, press the
corresponding program selection button. For example, to
select program 8, press
• To select a two-digit program number, press
entry)
, followed by the corresponding program selection
buttons. For example, to select program 28, press
(Program entry)
, and then
• To return to the previous viewed program or input, press
(Recall)
(also highlighted in the illustration).
To alter the volume, press the following buttons:
•
(Volume)
+ or
control (as highlighted in the illustration), or
• + or - on the remote control, or
•
or
on the TV.
on the remote control
.
(Program
,
.
(Volume)
- on the remote
Section 1: Quick Start Guide
9
Hide quick links:
Advertisement
Table of Contents
