Yealink SIP-T41P Configuration Manual page 70

Yealink IP Phones Configuring Guide
How the phone handles incoming multicast paging calls depends on Paging Barge and
Paging Priority Active parameters configured via CommPortal phone Configurator.
Priority Paging Group
The priority paging group defines the priority of the voice call in progress. If the priority
of an incoming multicast paging call is lower than that of the active call, it will be
ignored automatically. If priority paging group is disabled, the voice call in progress will
take precedence over all incoming multicast paging calls. Valid values in the priority
paging group field:
1 to 10: Define the priority of the active call, 1 with the highest priority, 10 with the

lowest.
0: The voice call in progress will take precedence over all incoming paging calls.

Paging Priority Enable
The paging priority enable parameter decides how the phone handles incoming
multicast paging calls when there is already a multicast paging call on the phone. If
enabled, the phone will ignore incoming multicast paging calls with lower priorities,
otherwise, the phone will answer incoming multicast paging calls automatically and
place the previous multicast paging call on hold. If disabled, the phone will
automatically ignore all incoming multicast paging calls.
To configure multicast listening addresses via web user interface:
1. Click on Paging Groups->Listening Group N.
2. Enter the group name in the Description field.
3. Enter the multicast IP address (e.g., 224.5.6.21) in the Address field.
The valid multicast IP addresses range from 224.0.0.0 to 239.255.255.255.
4. Enter the multicast IP port number (e.g., 10008) in the Port field.
5. Repeat the step 2-4, you can add more listening groups.
6. Click Save changes to accept the change.
7. Perform auto provisioning on the phone to download above configurations. For
more information on how to perform auto provisioning, refer to
Configuration Files
62
on page 7.
Downloading