Fs-100 Operating Instructions - Siemens FireSeeker FS-100 Installation, Operation And Maintenance Manual

Hide thumbs Also See for FireSeeker FS-100:
Table of Contents

Advertisement

FS-100 Installation & Operation Manual

FS-100 OPERATING INSTRUCTIONS

In case of alarm, the System Alarm LED flashes, LCD will display alarm conditions and the panel buzzer
sounds. Local audible and visual signals and remote alarm signals operate.
When an alarm occurs, proceed according to the established emergency plan. Assure that all personnel
are accounted for, and notify the Fire Department to advise of the alarm and/or verify that an automatic
signal has been received at the Fire Department.
To silence the alarm:
To silence the notification appliances after evacuation, where permitted, press the Alarm Silence
switch. The notification appliances and panel buzzer will be silenced, and LED indications will
change from flashing to continuous. The Alarm Silenced LED will be lit.
Note: Do not reset the panel until the alarm has been cleared.
Warning: Alarm silence inhibit (if set) prevents the alarm from being silenced for a
predetermined time.
To reset panel after alarm:
When the alarm condition is corrected, return the panel to normal standby operation by pressing
the System Reset switch.
Trouble is indicated by:
System Trouble LED flashes
LCD will display trouble conditions
Panel buzzer sounds
To silence the trouble buzzer:
Press the Trouble Silence switch. The Trouble Silenced LED lights and the specific trouble
LED(s) may change to continuous display. When the trouble condition has been cleared, you
may need to reset the panel to restore to a normal standby condition.
Warning: Leaving the panel in a trouble condition may cause a fire alarm condition not to
initiate a fire alarm sequence
The green AC Power On LED will be lit and no other indicators on
For service, contact: ___________________________________________
Telephone Number:
P/N 315-699461
Technical Manuals Online! - http://www.tech-man.com
Authorized Personnel Only
Normal Standby Condition
_________________________________________ __
Frame these instructions and mount them near the control unit for operator reference.
Alarm Operation
Trouble Operation
.
16

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents