System Events - Siemens FireSeeker FS-100 Installation, Operation And Maintenance Manual

C. System Events
ENTRY
Alarm Silenced
All AV Ctrs Clr
AutoProgram Run
Backup Cnfg Check
Backup Cnfg Edit
CMlaa ActvnCnfd
ConfigsCompared
ConfigsSwapped
EventHist Clear
Mnt Levl Enter
Mnt Levl Exit
Mnt Levl PW Changed
MM1aa Disabled
MM1aa Enabled
NACxx Active Confirm
Panel Reset
Power Up
PriConfigCopied
QuickTest Exit
QuickTest Start
SN1aa AV CtrClr
SN1aa AV CtrRll
SN1aa Disabled
SN1aa Enabled
System Date Changed
System Time Changed
Tech Levl Enter
Tech Levl Exit
Tech Levl PW Changed
User Levl Enter
User Levl Exit
P/N 315-699461
Technical Manuals Online! - http://www.tech-man.com
INDICATES/NOTES
MAIN, LCDxx shown on bottom line
All AV counters cleared
Auto programming function run
Backup configuration validated, result on bottom line
Backup configuration edited
Non-relay CM activation confirmed by trouble input on
Backup and primary configurations compared, result on bottom line
Backup and Primary configurations swapped
Event History cleared
Entered Maintenance level
Exited Maintenance level
Changed Maintenance level password
MAIN or LCDxx shown on bottom line
MAIN or LCDxx shown on bottom line
NAC activation confirmed
MAIN, LCDxx shown on bottom line
Primary configuration copied to backup
Exited Quick Test, MAIN or LCDxx shown on bottom line
Started Quick Test, MAIN or LCDxx shown on bottom line
AV counter for sensor SN1aa cleared
Alarm Verification counter rolled over to 0
MAIN or LCDxx shown on bottom line
MAIN or LCDxx shown on bottom line
Changed system date, old and new dates shown on lines 3 and 4
Changed system time, old and new times shown on lines 3 and 4
Entered Tech level
Exited Tech level
Changed Tech level password
Entered User level
Exited User level
45