Related Manuals for BESAFE iZi Kid ISOfix
Summary of Contents for BESAFE iZi Kid ISOfix
- Page 1 User manual 0-18 6m-4y 0+/1 www.besafe.eu ECE R44/04 Complies with revised standard: semi-universal 0-18 kg ECE R44/04 ECE R44/04 Tested and Approved R 44 04200...
-
Page 2: Table Of Contents
Kid ISOfix can only be installed rearward facing. The car must be equipped with ISOfix anchorage points. iZi Kid ISOfix is not allowed to mount in front passenger seat with an activated airbag. The floor support must always be used. - Page 3 DO NOT use on a passenger seat fitted with activated frontal airbag. AIRBAG Important: BeSafe iZi Kid ISOfix is only possible to mount in cars with ISOfix anchorage points, see the instruction manual of the car for more information.
-
Page 4: Preparing To Install
Preparing to install Crucial parts 1. Internal harness 2. Harness adjustment Front brace Switch for ISOfix connectors 5. Lever for sleeping positions 6. Ratchet for front brace 7. ISOfix connectors 8. Release button for ISOfix connectors 7. ISOfix installation connectors 9. - Page 5 Height can be adjusted by releasing the height adjustment device on the back of the iZi Kid ISOfix, place it in the correct position and clicking it in. Twist and pull the shoulder belts on the front side of the seat until the belts are adjusted into the correct position.
-
Page 6: Before Installation
If your car is not epuipped with ISOfix insertion clips (16), insert these to make installation easier. You can find the ISOfix insertion (16) clips under the base of your iZi Kid ISOfix. Clip the insertion clips into the anchorage points. - Page 7 Remove the plastic caps (9) from the ISOfix connectors (7) by pressing down the ISOfix release Use the ratchet (6) to adjust the front brace to the inmost position. The ratchet (6) is used to adjust the front brace in both directions. Switch the knobs on the ratchet to change direction.
-
Page 8: Installation In The Car
The BeSafe iZi Kid ISOfix must not be used in the front passenger seat without deactivating the airbag. BeSafe iZi Kid ISOfix is installed the same way in the front and back seat. Place the seat into the car by racing the seat with the front brace first. - Page 9 Pull both ISOfix connectors (7) as far out as possible. The switch (4) then goes into the lowest position and locks the connectors (7). Click the ISOfix connectors in the ISOfix anchorages. Click Make sure that the two indica- tors (10) are green, both in the hole and on the inside of the release gear.
- Page 10 Adjust the front brace outwards with the ratchet (6). Continue tightening until the brace is pressed well into the backrest of the car seat. If possible, push the front seat backwards so that it is in contact with the child seat. If it is not possible to obtain contact with the child seat, push the backrest of the front seat forward so that the distance between child seat and backrest is minimum 25 cm.
-
Page 11: Waring: Potential Misuse
NEVER use BeSafe iZi Kid ISOfix without tightening the front brace. ALWAYS make sure that the indicator for correct installation of the ISOfix anchorages shows GREEN. NEVER USE iZi Kid ISOfix on a passenger seat fitted with activated frontal airbag. -
Page 12: Sitting Positions
Sitting positions BeSafe iZi Kid ISOfix has 4 sitting positions. The sitting positions can be regulated by using the lever (5) Car seat protection To avoid damage to the fabric of the car seat, especially with leather car seats, protect your car seat... -
Page 13: Removing The Izi Kid Isofix
Removing the iZi Kid ISOfix If your iZi Kid ISOfix is installed in the back seat, push the front seat as far forward as possible. Adjust the backrest as far backwards as possible, when removing from the front seat. Remove the locking bolt (13) from the floor support (12). - Page 14 Push the switch (4) on each side, and push the ISOfix installation connectors (7) into the base. Pull the iZi Kid ISOfix back towards the front seat. Turn the seat so you can easily remove the seat. Remove your iZi Kid ISOfix from the car.
-
Page 15: After An Accident
After an accident, the iZi Kid ISOfix must be replaced. Although it may look undamaged, if you were to have another accident, the iZi Kid ISOfix may not be able to protect your child as well as it should. Guarantee All BeSafe products are carefully designed, manufactured and tested. -
Page 16: Removing And Refitting The Cover
Removing and refitting the cover Never use the iZi Kid ISOfix without the cover. The cover may only be replaced by an original iZi Kid ISOfix cover. ALWAYS use the harness provided with the iZi Kid ISOfix. Removing the cover Pay attention when you remove the cover, as fitting the cover is done in the opposite way. - Page 17 Washing instructions The cover of the iZi Kid ISOfix must be washed in accordance with the instructions (on the inside of the cover). Cleaning harness and seat DO NOT use any cleaning products; these may harm the construction material of the iZi Kid ISOfix.
-
Page 18: Important Advice
Unsecured luggage may cause severe injuries to children and adults in case of accident. Never use the iZi Kid ISOfix without the cover. The cover may only be replaced by an original iZi Kid ISOfix cover. The cover of the iZi Kid ISOfix must be washed in accordance with the instructions inside the cover. - Page 19 Kid ISOfix will not be able to protect your child as well as it should. DO NOT use the iZi Kid ISOfix for longer than 5 years. Due to ageing, the quality of the material may change. DO NOT use at home. It has not been designed for home use and can only be used in a car.
-
Page 20: Point Of Sale Information
The mass group and the ISOfix size class for which this device is intended is: C The iZi Kid ISOfix is suitable for fixing into the seat positions of the cars listed in the appendix ‘carlist’. Seat positions in other cars may also be suitable to accept this child retraint.