Fitting The Burner Door; Inserting The Hot Gas Baffles - Buderus Logano GE615 Installation And Maintenance Instructions Manual

4.11.3 Fitting the burner door

In the factory, the burner door hinge lobes are fitted on the
right-hand side. For left-hand closing, dismantle the hinge
lobes from the right-hand side and reassemble them on
the left-hand side of the burner door.
V Place a few drops of Silastik adhesive, 15 – 20 cm
apart, in the packing grooves on the front section.
z Insert GP packing cord into the packing groove on the
front section. Position the packing cord joint at the
side.
z Screw each hinge pin (right-hand closure) to the front
section with two hexagon bolts M12 x 55. For left-hand
closing, secure accordingly on the left-hand side.
z Hook the burner door hinge lobes into the hinge pins.

4.11.4 Inserting the hot gas baffles

The boiler, which consists of 16 sections,
does not contain any hot gas baffles.
A distinction is made between hot gas baffles
with a sickle profile and those with a
corrugated profile.
The hot gas baffles with a sickle profile come
in two parts. If equipping a hot gas flue with
sickle-profile baffles, you MUST ensure that
the two baffle parts are hooked together.
Æ Fig. 31, page 26 shows the baffle parts
hooked together.
V Take hot gas baffles from the fittings case and insert
into the hot gas flue according to the inscription on
them (Æ see Fig. 30, Fig. 31, page 26, Fig. 32,
page 26 and Tab. 1, page 5).
Logano GE615 - We reserve the right to make any changes due to technical modifications.
Fig 29 Fitting the burner door
1 Hinge pin (top)
2 Packing cord joint (side)
3 Hinge pin (bottom)
4 Hinge lobe (bottom)
5 Holes in the burner door
6 Hinge lobe (top)
Fig 30 Inserting the hot gas baffles (boiler block with 9
sections)
1 Hot gas baffles with sickle-profile (baffle part)
2 Hot gas baffles with sickle profile (hooked together)
4
Installation
25