Burner Door And Burner - Buderus Logano plus SB615 Installation And Servicing Instructions

The plastic coil (Fig. 16, Item 2) for holding together
the temperature sensor is pushed back automatically
when it is inserted.
USER NOTE
To ensure good contact between the well
(Fig. 16, Item 4) and the sensor surfaces
and thus establish reliable heat transfer, the
wavy spring (Fig. 16, Item 1) must be
placed between the temperature sensors.
7.3

Burner door and burner

The burner door can be hung on either side.
USER NOTE
To reverse the door swing, bolt the burner
door shut and swap the hinges.
Push the hinge bolts out of the hinges from underneath
(Fig. 17, Item 1).
Refit the washer and the two hinge pins on the other
side (Fig. 17, Item 2). Remember the washer!
Logano plus SB615 - Technical specifications are subject to change without prior notice.
1
2
4
Fig. 16 Inserting plastic coil in immersion sleeve
Item 1: Balancing spring
Item 2: Plastic coil
Item 3: Sensor retaining clip
Item 4: Well
2
Fig. 17 Reversing the door hinges
Item 1: Hinge bolt
Item 2: Washer
Installation
3
7
1
1
2
17