Table of Contents
Advertisement
5.4.4
Gamma
What can be adjusted ?
With the gamma correction adjustment, it is possible to accurately set the gamma of the projector image.
Changing the Gamma value
1. Push the cursor key ↑ or ↓ to highlight Gamma. (menu 5-35)
2. Press ENTER to select.
3. Change the gamma value by pushing the cursor key ← or → until the desired value is reached.
Note: Default value of gamma : 1.9
4. Press EXIT to return to the Picture Tuning menu.
PICTURE TUNING
MOTION COMPENSATION
COLOR TEMPERATURE
GAMMA
INPUT BALANCE
WINDOWING
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 5-35
5.4.5
Input Balance
Why adjusting the input balance?
The input balance is normally correct adjusted in the factory. But due to signal distribution or signal transmission outputs a color
imbalance can be the result. This imbalance can be adjusted source by source for color critical applications. These adjustments
influence only the actual custom adjustment file. This procedure is not so easy and is best done or first demonstrated by an autho-
rized Barco service technician.
Step to be taken
To adjust the input balance, the following steps have to be executed in the following order:
1.
The procedure is best done when using a source that can generate a full black and full white image.
2.
Start with the Black Balance.
3.
Continue with the White Balance.
The default values are normally loaded with the factory preset when selecting a source. If the image is not as
desired, continue with the next procedure.
How to start up Input Balance?
1. Push the cursor key ↑ or ↓ to highlight Input Balance and press ENTER to select. (menu 5-36)
The Input Balance menu will be displayed.
PICTURE TUNING
MOTION COMPENSATION
COLOR TEMPERATURE
GAMMA
INPUT BALANCE
WINDOWING
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 5-36
R5976496 BARCOREALITY SIM 6 MK II + WARP 6
15052003
TM
5. Random Access
51
Advertisement
Table of Contents
