Configuration; Osd Color; Internal Patterns - Barco BARCOREALITY SIM 6 MK II + WARP 6 Owner's Manual

6. Installation Mode

6.10 Configuration

What can be done ?
The way of physical installation of the projector can be defined to the projector.
The following installation configurations are possible:
• front/table
• front/ceiling
• rear/table
• rear/ceiling
Choosing the right configuration
1. Push the cursor key ↑ or ↓ to highlight Configuration. (menu 6-23)
2. Press ENTER to select.
The configuration menu will be displayed.
INSTALLATION
CONFIGURATION

OSD COLOR

INTERNAL PATTERNS

SHUTTER
ACTIVE 3D CONF.
MORE...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 6-23
6.11 OSD Color
What can be done?
The highlighted items on the menus can be displayed in red, green or yellow.
How to change the OSD Color ?
1. Push the cursor key ↑ or ↓ to highlight OSD Color. (menu 6-24)
2. Press ENTER to select.
The OSD color menu will be displayed. (menu 6-25)
INSTALLATION
CONFIGURATION
OSD COLOR
INTERNAL PATTERNS
SHUTTER
ACTIVE 3D CONF.
MORE...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 6-24
6.12 Internal Patterns
What can be done with these internal patterns?
The projector is equipped with different internal patterns which can be used for measurement purposes.
116
OSD COLOR
HIGHTLIGHTED ITEM
RED
GREEN
YELLOW
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 6-25
R5976496 BARCOREALITY SIM 6 MK II + WARP 6 15052003
TM