(3) Detaching and refitting the feed pulley and forwarding pulley
Follow the procedure below to clean or replace the feed pulley or forwarding pulley.
Procedure
1. Remove the DP rear cover and DP front
cover (See page P.1-5-51).
2. Remove the stopper.
3. Remove the bush.
4. Remove the stopper A and then remove
the DP paper feed clutch.
5. Remove the stopper B and then remove
the PF collar, spring, spring collar S, pin
and bush from the PF shaft.
PF shaft
DP paper
feed clutch
Spring
PF shaft
1-5-53
2PK/2PL/2PM/2PN
Bush
Figure 1-5-79
Spring collar S
Pin
Spring
Bush
Stopper A
PF shaft
Figure 1-5-80
Stopper
PF collar
Stopper B