Setting The T2 Time-Out Time; Setting The Ta Time-Out Time; Setting The Tb1 Time-Out Time - Kyocera ECOSYS M2030dn/PN Service Manual

Item No.
U641

Setting the T2 time-out time

The T2 time-out time decides the following.
From CFR signal output to image data reception
From image data reception to the next signal reception
In ECM, from RNR signal detection to the next signal reception
1. Change the setting using the cursor left/right keys.
Description
T2 time-out time
2. Press the start key. The value is set.

Setting the Ta time-out time

In the fax/telephone auto select mode, sets the time to continue ringing an operator through the
connected telephone after receiving a call as a fax machine (see figure 1-3-17). A fax signal is
received within the Ta set time, or the fax mode is selected automatically when the time elapses.
In fax/telephone auto select mode, change the setting when fax reception is unsuccessful or a
telephone fails to receive a call.
1. Change the setting using the cursor left/right keys.
Description
Ta time-out time
2. Press the start key. The value is set.

Setting the Tb1 time-out time

In the fax/telephone auto select mode, sets the time to start sending the ring back tone after
receiving a call as a fax machine (see figure 1-3-17). In fax/telephone auto select mode, change
the setting when fax reception is unsuccessful or a telephone fails to receive a call.
1. Change the setting using the cursor left/right keys.
Description
Tb1 time-out time
2. Press the start key. The value is set.
Description
Setting
range
1 to 255
Tb1
Tb2
Figure 1-3-17 Ta/Tb1/Tb2 time-out time
Setting
range
1 to 255
1-3-62
Initial Change in value
setting per step
69 100 ms
Setting range Initial setting
1 to 255 30
Ta
Initial Change in value
setting per step
20 100 ms
2PK/2PL/2PM/2PN