IDEAL Logic HEAT 12 Installation And Servicing page 24

26 FITTINg THE WALL PLATE / REAR FLuE TERMINAL ASSEMBLy
1. Ensure the rubber terminal wall seal is fitted to the terminal.
Refer to Frame 24.
2. Insert the previously cut to length terminal assembly into the
plastic connector.
3. Line up the mark on the top of the plastic connector with the
top of the terminal (marked with a label).
4. Drill 2 - 3.5mm dia holes through each side of the plastic
connector and the air duct and fit the two self tapping screws
(provided) to retain the duct terminal assembly to the plastic
connector.
5. Seal the joint between the plastic connector and the terminal
air duct with the tape provided.
6. Push the terminal assembly through the prepared hole in the
wall until the rubber seal clears the outside wall. Rest the
assembly in the hole while fitting the wall mounting plate.
7. Screw the wall monting plate to the wall using 2 wall plugs
(previously fitted) with the 2 screws provided. Choose one
of the 2 sets of slots in the left and right bank. Ensure that at
least one of the screws is fitted into a top slot.
8. Pull the flue assembly back through the wall mounting plate
to seal against the outside wall face and ensure the 3 locating
tabs are pulled through the wall mounting plate slots.
9. Turn the plastic connector clockwise to lock the connector into
the wall plate.
10. Retain with the M5 screws provided.
8
24
INSTALLATION
8
10
3
9
Ideal Logic Heat -
Installation and Servicing
2
5
4