Table of Contents
Advertisement
5
PART REMOVAL
Negative battery cable disconnection
1. Set the selector lever to D range.
2. Disconnect the negative battery cable and wrap tape around it to insulate.
WARNING
• When the negative battery cable is connected during operation, it may cause electric shock or other
personal injuries. Disconnect the negative battery cable before removal/installation.
Front scuff plate inner
Tab D
Pin C
Front side trim
Nut
Console panel
Vehicle front
Tab A
Clip B detail
Clip B
Clip A detail
Vehicle front
Clip A
Vehicle front
Mazda CX-7－7
Front scuff plate inner (passenger's side) removal
CAUTION
•
Be careful not to damage the scuff plate during
removal.
1. Pull the front scuff plate inner upward while detaching tabs
A, detach clips B, pins C and tab D from the body, and
then remove the front scuff plate inner.
Front side trim (passenger's side) removal
1. Remove the nut using 14mm socket.
CAUTION
•
Be careful not to tear the seaming welt when puling it
out.
2. Pull the front side trim in the direction shown by the arrow,
then detach clip A.
Console panel (driver's and passenger's side)
removal
1. Remove clips A in order starting from the vehicle rear
using a tape-wrapped flathead screwdriver.
Advertisement
Table of Contents
