Antenna
Vehicle front
Ⓐ
Antenna cable
Seaming welt
Vehicle front
Do not put pad protectors
within 35 {1.37} of opening
Butyl tape
To trunk compartment
Ⓑ
20 {0.78}
60 {2.36}
30 {1.18}
Seaming
Pad protector 1/2
welt
5. Clean the adhesion area on the trunk lid with isopropyl
Clip
6. Attach the clip to the vehicle as shown in the figure.
7. Install the antenna cable to the clips.
Ⓐ
Clips
Antenna cable
8. Pull the seam upward and route the antenna cable in the
9. Reinstall the rubber seaming welt to its original position.
Ⓑ
10. Clean the adhesion area with isopropyl alcohol (IPA).
11. Secure the antenna cable in place with the butyl tape and
Antenna cable
Antenna cable
Vehicle front
mm {in}
Mazda CX-7-18
alcohol (IPA).
seaming welt. (Does not need to be completely removed)
CAUTION
•
It is critical that the antenna follows the route as
shown. Failure to follow this route will not provide the
slack required to open and close the liftgate.
•
Be careful not to tear the seaming welt when pulling it
up.
•
Do not remove trunk seam from the flange. The
antenna cable must not interfere with the flange seals.
pad protector halves.
CAUTION
•
To ensure proper affixing, be sure to degrease the
area where the pad protector is affixed.
•
Do not wrap butyl tape around flange.
•
Do not double-layer tape.
Butyl tape should hold the antenna cable to the sheet
metal as shown.
•
Take care not to trap antenna cable under attachment
nuts.