10
INSTALLING THE HARNESS (H5)
Installation of SIRIUS and iPod integration module
70 {2.75}
Vehicle front
Vehicle wiring harness
Vehicle front
Vehicle wiring
AUX or Bluetooth H/F
16 pin connector harness
harness
50 {1.96}
Vinyl tape
Harness (H5)
Tie wrap (large)
ⓐ
Harness tube
(Audio 24-pin connector)
mm {in}
Harness tube
(Vehicle wiring
harness)
mm {in}
Antenna cable
DLP unit
Vehicle front
1. Cut the harness tube of the audio 24-pin connector as
shown in the figure.
CAUTION
•
When cutting the harness tube, be careful not to
damage the wiring harness.
If not, it may cause a short, accident, or fire.
2. Cut the harness tube of the vehicle wiring harness as
shown in the figure.
CAUTION
•
When cutting the harness tube, be careful not to
damage the wiring harness.
If not, it may cause a short, accident, or fire.
3. Bend back the harness tube, move the AUX or Bluetooth
H/F connector harness, and change the branch point.
CAUTION
•
Do not apply excessive force to the wiring harness as
it could cause an open circuit.
4. Wrap the cut harness tube and the vehicle wiring harness
with vinyl tape.
5. Wrap the cut harness tube and the AUX or Bluetooth H/F
connector harness with vinyl tape.
6. Connect the harness (H5) to the DLP unit.
(See step 6 on page 16 as to the installation position.)
7. Bundle the harness (H5) and antenna cable using a tie
wrap (large) as shown in the figure.
Mazda CX-7-23