Table of Contents
Advertisement
11
REINSTALLATION OF VEHICLE PARTS
• Install in the reverse order of "5. Part removal".
CAUTION
•
After installing the vehicle parts, check for dirt. Clean any dirty parts.
• Perform the Inspection indicated on the last page of these installation instructions.
CAUTION
• Disconnecting the battery causes the DSC indicator light to become inoperable.
(At this point, the DSC OFF indicator light flashes and the TCS/DSC indicator light is illuminated.)
• To restore the DSC to an operable condition, perform the following procedures:
1. Turn the ignition switch to the ON position.
2. Turn the steering wheel completely to the right and then completely to the left.
3. Verify that the DSC OFF indicator light turns out.
4. Turn the ignition switch off and then turn it to the ON position again.
5. Verify that the TCS/DSC indicator light turns out.
If the TCS/DSC or DSC OFF indicator lights do not turn off after turning the ignition switch to the ON
position, consult your Mazda dealer.
• When the battery is disconnected, the windows will not fully open and close automatically.
Perform the following procedure to resume operation:
1. Turn the ignition switch to the ON position.
2. Press the switch and fully open the window.
3. Pull up the switch and continue holding for about 2 seconds to fully close the window.
4. If the function does not operate even after the ignition switch is turned off, contact an Authorized
Mazda Dealer.
Mazda CX-7－31
Advertisement
Table of Contents
