Mazda 0000 81 M09 Installation Instructions Manual page 11

Hazard switch connector
Audio side connectors
Vehicle front
Bolt
Pin
Screws
Audio unit
Screws
Bolt: 6.9－9.8 N･m
{71.0－99.0 kgf･cm, 61.0－86.0 in･lbf}
Climate control unit connector
Climate control unit
Screws
Meter hood
Vehicle front
Upper column cover
Audio unit removal
•
When installing the audio unit, make sure that the
wiring harness and antenna feeder are not caught
Pin
between the unit and dashboard. If the wiring harness
or the antenna feeder is caught between the unit and
dashboard, it may cause malfunctions.
•
Pressing the switch area of the audio unit when
installing it could result in a malfunction. Therefore
only press the hatched area shown in the figure.
Pin
1. Remove the bolt.
2. Remove the screws.
3. Pull the audio unit outward slowly and detach pins.
4. Disconnect the audio side connectors, antenna feeder,
and hazard switch connector, and then remove the audio
unit.
Climate control unit removal
1. Remove the screws.
Vehicle front
2. Release the tab and pull the climate control unit toward
you.
3. Disconnect the climate control unit connector.
4. Remove the climate control unit.
Tab
Meter hood removal
1. Pull the upper column cover upward and detach the upper
column cover from the lower column cover.
Clip A
2. Pull the meter hood and remove clips A and tabs B.
3. Remove the meter hood.
Tab B
Mazda CX-7－11
CAUTION