Paging The Parent Unit; Talk Function - Philips SCD570 User Manual

EngliSh
8

paging the parent unit

If you have lost the parent unit, you can use the FIND button on your baby unit to locate the parent
unit. This function only works when the parent unit is switched on.
1 Press FIND on the baby unit and the parent unit produces a paging alert tone (Fig. 5).
2 To stop the paging alert tone, press FIND on the baby unit again or press any button on the
parent unit. The paging alert tone stops automatically after 2 minutes.
Battery status light
1 The battery status light is solid green when the baby unit runs on battery power and the
batteries contain enough energy.
2 The battery status light flashes red quickly when the batteries run low while the baby unit is
running on battery power.
- Replace the batteries when they run low.
Functions and feedback on the parent unit
volume
The volume can be set if the menu is not active. There are seven volume levels and a 'volume off '
setting.
Setting the volume level
1 Press the + button or the - button once.
The current volume level appears on the display.
,
2 Press the + button to increase the volume or press the - button to decrease the volume.
If no button is pressed for more than 2 seconds, the volume level indication disappears and
,
the volume setting is saved.
volume off
Below the lowest volume setting, there is a 'volume off ' setting.
1 Press the + button or the - button once.
The current volume level appears on the display.
,
2 Press and hold the - button for more than 2 seconds to set the volume to off.
The message 'MUTE' and the mute symbol appear on the display (Fig. 6).
,
Note: If the volume is off, only the sound level lights show that the baby produces sounds.

talk function

1 If you want to comfort your baby, press TALK on the parent unit and talk clearly into the
microphone on the front from a distance of 15-30cm (0.5-1ft) (Fig. 7).
Note: If you have set the volume for the lullaby higher on the baby unit, the sound will also be louder
when you use the talk function on the parent unit.
The 'link' light starts flashing green and 'TALK' appears on the display.
,
2 Release TALK when you have finished talking.