Double Din /Stacked Iso Mount Unit(S) Provision - Metra Electronics MAZDA 6 2009 99-7511S Installation Instructions Manual

DOUBLE DIN/STACKED ISO MOUNT
*
Note: Refer also to the instructions included with the aftermarket radio.
1 Attach the filler trim panel to the back
of the radio housing at the bottom
edge. (Figure A)
2 Cut and remove the center bar from
the Radio Housing. (Figure B)
3 Snap the Double DIN brackets to the
inside edge of the Radio Housing.
(Figure C)
4 Slide the Double DIN or stacked ISO
mount unit(s) into the bracket/radio
housing assembly and secure to the
assembly using the screws supplied
with the unit(s). Snap the DDIN Trim
Plate onto the front of the Radio
Housing. (Figure D)
Continue to final assembly.
D
99-7511S KIT ASSEMBL Y
UNIT(S) PROVISION
A
REAR OF RADIO HOUSING
B
C
4
FILLER TRIM PANEL