Iso Mount Radio Provision - Metra Electronics MAZDA 6 2009 99-7511S Installation Instructions Manual

*
Note: Refer also to the instructions included with the aftermarket radio.
1 Attach the filler trim panel to the back
of the radio housing at the bottom
edge. (Figure A)
2 Mount the ISO Brackets to the radio
using the screws supplied with the
radio. (Figure B)
3 Slide the radio into the radio housing
until it snaps into place. (Figure C)
4 Snap the Trim Plate onto the front of
the Radio Housing. (Figure C)
5 Snap the pocket into the bottom open-
ing of the radio housing. (Figure D)
Continue to final assembly.
D
99-7511S KIT ASSEMBL Y

ISO MOUNT RADIO PROVISION

A
REAR OF RADIO HOUSING
B
C
3
FILLER TRIM PANEL