Installing Dimm Module; Installing The Scsi Board - Panasonic KV-S2065L Service Manual

KV-S2065L / KV-S2065W
4.5.

Installing DIMM Module

Insert the DIMM module into the connector on the SCSI interface
board at an angle [ Place ( 1 ) ]. Push in the module as far as it goes.
The levers should lock automatically. If not, push the levers to lock
the module in [Place ( 2 ) ].
Note:
• • Be sure that the DIMM module will be in the proper position
and the proper side.
• • To remove the DIMM module, release the white levers at both
sides of the connector.
4.6.

Installing the SCSI Board

1) Insert the SCSI Board into the unit along the rails and push it in firmly.
Confirm that the SCSI board plate is fully inserted until it firmly
locks in place.
2) Secure the SCSI Board with the 2 screws.
3) Install the scanner driver software in your computer according to the
enclosed manuals.
10