Panasonic KV-S2065L Service Manual page 13

(3) Press the SELECT [
desired setting.
The [ ] Key moves to the next ID as shown below.
The [ ] Key moves to the previous ID.
(4) Press the MODE Key [
setting.
To active the SCSI ID settings, press the HOME Key to
return to "READY", then turn the unit off and on.
(5) Press the SELECT [
desired setting.
The [ ] Key moves to the next content as shown below.
The [ ] Key moves to the previous content.
Note:
• • If the scanner is the last device in the SCSI chain,
then the terminator should be set to "Enable". But,
under the above SCSI chain and scanner's turn-off,
the terminator should be attached to the SCSI
connector on the scanner.
• • Setting the SCSI ID will be activated after turning the
power OFF and turning it ON again.
• • Setting the terminator will be activated after turning
the power OFF and turning it ON again.
] Key or [ ] Key to select the
] to switch to the terminator
] Key or [ ] Key to select the
13
KV-S2065L / KV-S2065W