3. Place your finger on the Paper Feed Roller Block Shaft and pull it towards you to remove the Paper Feed Roller Block from the
magnet [(1)]. Push down the Green Lock Levers and remove the Paper Feed Roller Module from the scanner by holding the
Green Lock Levers [(2)].
Note:
The Paper Feed Roller Block is attached by magnetic power. When moving the Green Lock Lever, do not apply pressure
in any other direction than the arrows. Otherwise, they may break.
4. Open the optional "Roller Exchange Kit (KV-SS009)", and take out the Paper Feed Roller Module.
5. Install the new Paper Feed Roller Module with the gear on the left side and the bearings into the guide grooves of the side
chassis in the scanner [(1)]. Then push up the levers on both ends until they click into place [(2)].
Note:
Match the Paper Feed Roller Module with the bearings and guide grooves, and then attach it.
25
KV-S2065L / KV-S2065W