8.3.11. Feed Motor
(1)
Remove Drive Roller-1. (See 8.3.4-(1), (2), (3))
(2)
Remove the screw (A) from the Retard Transmission Shaft
Holder.
Note:
When reattach a rink spacer to the scanner, be careful
with the direction of the spacer.
(3)
Remove 3 screws (B).
(4)
Remove the Feed Motor with the Attachment Plate screws.
(5)
Disconnect the connector from the DRIVE Board to this
motor.
8.3.12. Turn Conveyor Plate (Inner)
(1)
Remove the Pre Imprinter Door. (See 8.2.6)
(2)
Remove 4 screws.
(3)
Remove the 4 claws.
(4)
Disconnect CN526.
37
KV-S2065L / KV-S2065W