Table of Contents
Advertisement
If you have changed the configuration of the system-board tray, you might have to
update the server configuration through the Setup utility (see "Updating the server
configuration" on page 51).
Reinstalling a 3U chassis in an iDataPlex rack
Statement 4:
≥ 18 kg (39.7 lb)
CAUTION:
Use safe practices when lifting.
To reinstall a 3U chassis in an iDataPlex rack, complete the following steps:
1. Align the 3U chassis with the rails on the iDataPlex rack; then, slide the 3U
2. Install the M6 screws that secure the chassis to the rack.
3. Install the hard disk drives (see "Installing a hard disk drive" on page 36).
4. Reconnect the cables on the front of the system-board tray.
5. Turn on the system-board tray (see "Turning on the system-board tray" on page
6. Make sure that the power-on LED on the system-board tray operator panel is lit
50
System x iDataPlex dx360 M3: User's Guide
chassis into the rack until it is fully seated.
21).
continuously, indicating that the system-board tray is receiving power and is
turned on.
≥ 32 kg (70.5 lb)
≥ 55 kg (121.2 lb)
Advertisement
Table of Contents
